Zenith HW20H52DT Manuel de service télécharger pdf (Page 18)

3828VD0205B 2-2 CH-FLAT - FACTORY MENU

FACTORY MENU(continued)

16-F WHITE COMP: (White Compression) Rage o-1. 0=

Enable and 1=Disable

17-F TRAP 3.58: Zero is off and one is on. Set to 1 for

normal TV operation. Set to 0 if Y/C is used or chassis

has a comb filter.

18-F 60HZ SW: (60 Hertz Switched) The range is 0 to 2.

19-F PIF VCO: (PIF Voltage Controlled Oscillator) Range

is 0 to 127.

20-F RF BAND PASS: Sets adjustment range of the cus-

tomer control for brightness in therefore mode. Range is

0-1. Set to 1.

21-F RED CUT: B&W tracking adjustment. Range is 0-

254. Typical value is 70.

22-F GREEN CUT: B&W tracking adjustment. Range is 0-

254. Typical value is 70.

23-F BLUE CUT: B&W tracking adjustment. Range is 0-

254. Typical value is 70.

24-F GREEN GAIN: B&W tracking adjustment. Range is 0-

254. Typical value is 45.

25-F BLUE GAIN: B&W tracking adjustment. Range is 0-

254. Typical value is 70.

26-F VERT SIZE: (Vertical Size) Range is 0-254.

27-F HORZ SIZE: (Horizontal Size) This register does not

have any effect.

28-F VERT PHASE: (Vertical Phase) Range is 0-7.

29-F HORZ PHASE: (Horizontal Phase)

Range is from 0-31.

30-F AIR AFT: Force to AFC in Air Band.

Range is 0/1. Typical value is 0.

31-F EN LA7222: This register does not have any effect.

32-F CUT OFF RESET:

33-F GAW RESET:

34-F RF WHITE ADJ:

35-F BLACK ADJ:

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 47 48

Pas de commentaire

Zenith HW20H52DT Manuel de service Page 18